Dewen;

I don't know anything about Netcat, so I'm taking a stab in the dark here, but it looks as if
you're pointing Netcat at port 1230, while your config file indicates that Stunnel would be
listening on port 12035.  Try redirecting Netcat to the listening port.

If you need to post again, please indicate the version of Stunnel you are using, and what
platform your are running it on.

Regards;

Thomas


On 3/16/2012 5:35 PM, Dewen Kong wrote:

Hi all,

 

I am a new guy to stunnel.

 

here is the issue I meet, i install my stunnel in the lab. and trying to run the test with netcat.

 

Here is the config file i test:

 

 

client side:

...

...

output = stunnel.log

client = yes

[ncat]

accept = 12035

connect = ***.***.***.***:1230

then I run "stunnel test.conf "and the the log file shows configuration successfully

 

then I run the command  "cat test.file | netcat ***.***.***.*** 12035 on the client side

and run netcat -l -p 1230 > output

nothing happens.

And I check the log file. there is no record about the netcat.  I don't know what happened.

 

 

--
Dewen Kong

_______________________________________________
stunnel-users mailing list
stunnel-users@stunnel.org
http://stunnel.mirt.net/mailman/listinfo/stunnel-users

-- 
Attention: This message and all attachments are private and may contain information that is confidential and privileged. If you received this message in error, please notify the sender by reply email and delete the message immediately. 

_______________________________________________
stunnel-users mailing list
stunnel-users@stunnel.org
http://stunnel.mirt.net/mailman/listinfo/stunnel-users

-- 
Attention: This message and all attachments are private and may contain information that is confidential and privileged. If you received this message in error, please notify the sender by reply email and delete the message immediately.