Hi,
I am newbie to stunnel.As
mentioned in some of your posts i just gone through ..how to enable ipv6
support.
While configuring i did the same by giving the
following command.
./configure --enable-ipv6
make
make install
and i ran stunnel which listens at some port and i
have my own server which listens for stunnel.
I have enabled IPV6 ip When my client tries to
connect to my ipv6 ip and the port(stunnel listens) where my it is
listening...Its failed to connect.
Could you please throw some light on how to enable
IPV6 support for stunnel apart from what i tried.
Thanks in advance
Sandhya