Hi Martin,

What you need is an exec+connect section:

[ppp]
client = yes
pty = yes
retry = yes
exec = /usr/sbin/pppd
execargs = pppd <your parameters>
connect = STUNNEL-SERVER-IP:723
CAfile = /etc/stunnel/ca.crt
cert = /etc/stunnel/client.crt
key = /etc/stunnel/client.key
verifyChain = yes
checkHost = hostna.me

See the manual for documentation of the new options (pty, retry, exec, execargs).

Best regards,
    Mike

On 17.04.2019 18:43, Martin Got wrote:
How to use 'stunnel' in client mode to accept connections on pty from local programs like 'ppp' instead of 'accept=IP:PORT'?

'pty = yes' seems work in server mode only, so when I removed
'accept = 127.0.0.1:1723' from 'stunnel' client config I'm getting the error:

[!] Service [ppp]: Each service must define two endpoints on stunnel-5.44

I need to call 'stunnel' client from 'pppd' and communicate with 'stunnel' using pty if it was possible by using a command:

pppd /dev/ptyp3 10.0.1.2: local debug noauth passive noccp novj novjccomp nopcomp noaccomp name ppp-client connect 'stunnel /etc/stunnel/stunnel-client.conf'

Both 'pppd' and 'stunnel' started by executing the command above, but 'pppd' can't communicate to 'stunnel' server using pty.

Please advice.

[ppp]
client = yes
accept = 127.0.0.1:1723 
^^^^^^^^^^^^^^^^^^^^^^^
connect = STUNNEL-SERVER-IP:723
CAfile = /etc/stunnel/ca.crt
cert = /etc/stunnel/client.crt
key = /etc/stunnel/client.key
verifyChain = yes
checkHost = hostna.me
;checkIP = 1.2.3.4

_______________________________________________
stunnel-users mailing list
stunnel-users@stunnel.org
https://www.stunnel.org/cgi-bin/mailman/listinfo/stunnel-users